News
-
How to laser mark on LED lamps
The prospect of LED lamp market is bright with increasing demand of manufacturing capacity also needs to be improved continuously the traditional method of display silk screen can be easily erased and fake information, fake product information, non-environmental protection, low efficiency,. and c...Read more -
How to choose wood products laser engraving and wood box laser printer to mark wood products?
Regarding the marking of wood products, wood products combine the life needs and aesthetic pursuits of modern society. They are widely used in furniture and handicrafts and are very popular in society. Wood products mainly include furniture wood products, office wood products, craft wood products...Read more -
Clothing fabric laser cutting machine, cotton linen silk woolen leather chemical fiber blended yarn-dyed fabric laser cutting machine
Cotton linen, silk woolen leather, chemical fiber blended yarn-dyed fabric laser cutting machine is a clothing fabric laser cutting machine, used in the field of cutting cotton, linen, silk woolen leather, chemical fiber blended yarn-dyed fabric. It has a CCD high-precision system. Cotton, linen,...Read more -
How to print patterns on mobile phone cases, mobile phone back covers, and tablet protective cases?
The mobile phone case laser engraving and marking machine is suitable for various materials, such as: plastic mobile phone cases, silicone mobile phone cases, PC mobile phone cases, metal tempered mobile phone cases, glass mobile phone cases, wooden mobile phone cases, leather mobile phone cases,...Read more -
What are the applicationof CO2 laser marking machines and which non-metallic materials are they suitable for?
The working principle of the CO2 laser marking machine is basically focusing a high-power laser beam on the surface of the material, so that the local area of the material surface is instantly heated, melted and forms a mark. In this process, the energy of the laser beam is absorbed by the mate...Read more -
Reasons why laser output power is weak
The laser output power of new machines that have not been used for a long time is weak for the following reasons: Does the laser output power measured at the factory meet the technical specifications? Whether the tuning accuracy of the resonance gap meets the requirements; Check for light leakage...Read more -
In summer, the water chiller is prone to high temperature alarms
This problem is usually caused by weather that is too hot, extreme cold that does not remove heat well or does not have enough cooling capacity. Self-made cosmetics do not have the problem of sufficient cooling capacity. In general, the heat pipe is very dirty and the ventilation is not good, cau...Read more -
Why can’t I cut through the steel plate?
Why doesn’t the steel plate cut? After the analysis, it can be seen that the main reasons are as follows: The choice of nozzle from the laser head is not suitable for the thickness of the processed board; The speed of the laser cutting line is very fast and control of the operation is neces...Read more -
Solutions to abnormal sparks when cutting mild steel
What should I do if there are abnormal sparks when cutting mild steel? This situation affects the quality of the finishing part in the finishing part. During this time, if the other parameters are normal, the following conditions should be observed: nozzle head laser NOZZEL loss, replace the nozz...Read more -
What should I do if the laser tube has no light?
1. Sewage level switch. 2. High voltage lines are interrupted. 3. The laser tube is broken or burned. 4. The laser power supply is broken. 5. Water circulation “including blocked water pipes and non-working water pumps” 6. The waterproof line is broken or the contact is bad. 7. There ...Read more -
Analysis of deformation of small holes (small diameter and plate thickness) during laser cutting
This is because the machine tool (only for high-power laser cutting machines) does not use blasting and drilling to make small holes, but pulse drilling (soft puncture), which makes the laser energy also concentrated in a small area. The non-processed area will also be burnt, causing hole deforma...Read more -
How to solve the problem of burrs on the workpiece when laser cutting low carbon steel
According to the working and design principles of fiber laser cutting, the analysis shows that the following reasons are the main causes of burrs in the workpiece: The upper and lower positions of the laser focus are incorrect, and the focus position test needs to be performed and adjusted accord...Read more